KYOCERA I/F IB-21E DRIVER

The default message language is English. Data can be received but will not be printed until the printer is on-line by pressing the GO key. Table 4. Depending on the binding type and print orientation, the duplexer provides four types of binding. Do not let the opening of the waste toner box face downward.

Uploader: Shajas
Date Added: 27 January 2009
File Size: 39.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 1206
Price: Free* [*Free Regsitration Required]

If a problem cannot be corrected, contact your Kyocera Mita dealer. Starter Toner Containers The toner containers packed with the new printer are starter toner containers. Virtual Mailbox Virtual mailbox is part of Job Storage, which stores print jobs on the hard disk without printing. The paper size is set for the paper cassette.

Kyocera FS-2000D Advanced Operation Manual: Ib-21e/ib-30 Network Interface Cards

Figure 2 If paper is jammed at the standard paper cassette Cassette 1open and close the paper transfer unit the paper jam error will be reset. Initial sleep mode setting Power consumption in sleep mode 15 minutes 60 minutes 21 W 45 W [for U. Each mailbox may be used by an individual who desires to share the printer in this mode. For details, kkyocera Appendix A Options, section A.

Macintosh is a registered trademark of Apple Computer, Inc.

Pull the release lever on the left side guide and slide to the desired paper size. Note default settings made using the operator panel may be overridden by the printer driver settings and application software. The font size can be set between 4 and Initial sleep mode setting 15 min. Load paper into the paper cassette as displayed in place u/f.

  MEDION MD 6136 DRIVER DOWNLOAD

Download Center

To format the hard disk, follow the procedure in the Installation Guide of the hard disk. The audio alarm is set to On when leaving the factory. Figure Proceed to the next section and replace the waste toner box. Whether or not the jammed pages are reproduced normally after printing is resumed depends on the location of the paper jam. The printer again reads it from the beginning of the data. It is therefore recommended that you consult with your service representative in regard to cleaning of internal parts.

You can also change the number of copies when resuming printing from the operator panel. Connect the equipment into an outlet on a circuit different from that used i/ the receiver. The total number of printed pages can also be checked on the status page.

This practice will increase your office productivity. Chapter 3 Using the Operator Panel This chapter explains the message display, indicators and keys on the operator panel, and how to make various settings from the operator panel. Note If the optional duplexer is installed on the printer, you can set whether or not to enable duplex printing as follows.

  3D PROPHET 4000XT PCI DRIVER

The printer will also support other types of paper as long as they meet the standards explained in this chapter. Note that some types of special paper do not allow feeding from the paper feeder cassette.

Kyocera Ibe Ethernet 10/ Internal Print Server | eBay

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. When the formatting is successfully completed, the printer automatically prints out a format information page, which k/f you to check the memory card for proper formatting.

Labels arranged with gaps in-between can easily be peeled off during printing, causing serious jam problems. Error information is cleared when the printer is powered off. However, paper with surfaces that are too smooth may cause multiple-sheet feeding and fogging problems fogging is a gray background effect.

The administrator can preset the maximum number of pages that each department will be allowed to print. Press the GO key to resume printing.